3068 Wyeast Weihenstephen Weizen Yeast - Use By 10/01/2025 REDUCED

Wyeast ™ 3068 Weihenstephen Weizen yeast

The classic and most popular German wheat beer strain used worldwide. This yeast strain produces a beautiful and delicate balance of banana esters and clove phenolics. The balance can be manipulated towards ester production through increasing the fermentation temperature, increasing the wort density, and decreasing the pitch rate. Over pitching can result in a near complete loss of banana character. Decreasing the ester level will allow a higher clove character to be perceived. Sulfur is commonly produced, but will dissipate with conditioning. This strain is very powdery and will remain in suspension for an extended amount of time following attenuation. This is true top cropping yeast and requires fermenter headspace of 33%.
Flocculation: low
Attenuation: 73-77%
Temperature Range: 64-75° F (18-24° C)
Alcohol Tolerance: approximately 10% ABV
Dunkelweizen
Fruit Beer
German Hefe-Weizen
Roggenbier (German Rye Beer)
Weizen/Weissbier
Weizenbock
Instructions for the proper use of Activator™ packages:
1. To activate, locate and move inner packet to a corner. Place this area in palm of one hand and firmly smack package with the other hand to break inner nutrient packet. Confirm inner packet is broken.
2. Shake the package well to release the nutrients.
3. Allow package to incubate and swell for three hours or more at 70-75°F (21-24°C) or immediately direct pitch into wort.
4. Use sanitizing solution to sanitize the package before opening.
5. Shake well, open and pour Activator™ into five gallons of well-aerated or oxygenated wort at 70-75°F (21-24°C). Maintain temperature until fermentation is evident: by CO2 bubble formation, bubbling airlock or foaming on top of wort.
6. Adjust to desired fermentation temperature.
Full swelling of Activator™ packages is not required for their use. The contents of Activator™ packages may be direct-pitched without prior activation. Our smack pack technology is intended to be a tool for your use in determining viability, and in initiating metabolism for faster starts to fermentation.
Swelling of the packs before they are smacked .If the packs warm up, dissolved CO2 in the yeast slurry will come out of solution and cause the pack to swell. It is not going from liquid to a gas state.. the liquid form of CO2 only exists at extremely high pressure or extremely low temperatures.
The swelling DOES NOT indicate that there is an infection or cross contamination
Please note the wyeast yeasts are sent out without any cooling products, we been selling liquid yeasts for years and have very little trouble Just try to avoid ordering on a Friday as they could be sat in the Parcel Force depot over the weekend.
When using any liquid yeasts good idea to have a dried yeast as a backup